Power Supplies

1.30VOLT 0.15.6AMPER SMPS PART-1 SCHEMATIC CIRCUIT DIAGRAM

I stopped for a long time 🙂 My Project Project Project is not implemented in the first tests I did before the 2008 circuit will continue 0-20V 0-10 Smps formed on the circuit modifiyede I did modified again.

CAUTION Be careful that the circuit works with high voltage Caution when connecting the condenser + – If you connect the poles upside down, you may have large explosions at high voltage before operating the circuit Fuse Electrical Line, use protective goggles

Applied circuit 1..16 volt previously explained with the method I run 1..30 volts I could not use the full value of some resistors I used the closest values ​​with the serial connection

Quick diodes used at SMPS output are disassembled from scrap atx power supply,

1.30VOLT 0.15.6AMPER SMPS PART-1 SCHEMATIC CIRCUIT DIAGRAM 1

Two pieces for load 12v 50w lamps were used in series. Unfortunately, I did not have any other lamp.

1.30VOLT 0.15.6AMPER SMPS PART-1 SCHEMATIC CIRCUIT DIAGRAM 2

12v bits used in the transformer 5v and the chassis is not usually used as in the picture is different from the ones you are going to experiment with before using the transformer check the leg connections on the circuit board will use PC Powersupply, atx P3 or P4 can be the control integral of the TL494 does not actually need to be transformers but with pc power, If you are not very busy 🙂 You can not solve the compatibility of tafos do not want to take risk use power with control tl494

1.30VOLT 0.15.6AMPER SMPS PART-1 SCHEMATIC CIRCUIT DIAGRAM 3

The project was not completed, but I do not think it would be a surplus SMPS project I can even say 🙂 a few changes in the current will be limited to 6 amps according to the tests can be changed the value of several elements 6 amps I think the most appropriate value than 10 amperes will change the circuit.

1.30VOLT 0.15.6AMPER SMPS PART-1 SCHEMATIC CIRCUIT DIAGRAM 4

1.30VOLT 0.15.6AMPER SMPS PART-1 SCHEMATIC CIRCUIT DIAGRAM 5

1.30VOLT 0.15.6AMPER SMPS PART-1 SCHEMATIC CIRCUIT DIAGRAM 6

The full form of SMPS is Switched Mode Power Supply also known as Switching Mode Power Supply. SMPS is an electronic power supply system that makes use of a switching regulator to transfer electrical power effectively. It is a PSU (power supply unit) and is usually used in computers to change the voltage to the appropriate range for the computer.

Tags

Related Articles

Leave a Reply

Your email address will not be published.

Check Also
Close
Back to top button
Close
Close