voltage converter

DC to DC Converter with voltage up

The converter raises a direct voltage to almost twice its level and is, therefore, particularly suited to increase the output of solar cells to the level required for charging lead-acid or NiCd batteries. It can deliver a current of up to 3 A. Measurements with a load current of 2 A are given in the table. The open-circuit out-put voltage is about 1-1.5 V higher. In the following description it is assumed that the input voltage to the Circuit is 12 V and the output voltage 22 V. IC-1a, R2 and C5 form a rectangular-voltage generator. This signal is also available in inverted form at the output of IC-1d.

Description of DC to DC converter circuit:

Network R2C6 delay the output of IC-1a, so that the output I of NAND gate IC-1b has a duty factor >0.5 (the negative half is shorter than the positive half). The same is true of the output of NAND gate IC-1c. (The input signal to this gate is delayed by R5-C7).

The output of IC-1c is inverted and buffered three times: in IC-3f, 1C-3a, and the four paralleled gates 1C-3b–1C-3e. It is then used to drive power FET T3.

DC to DC converter circuit diagram:

The output of IC-1b drives small-signal transistor T1. When this transistor is on, junction R6-R7 is pulled to 2 V without diode D1. However, IC-2a needs an input signal 11-22 V, since the supply voltage for this inverter (and, of course, also for inverters IC-2b –IC-2e) as well as the collector voltage of T1 is already derived from the doubled output voltage. The negative supply voltage for this IC is therefore derived from the positive input voltage. Diode D1 ensures that potential at the input of IC-2a does not drop below 10.5 V.

Transistors T2 and T3 conduct alternately. When T2 is on, C10 is charged to the level of the input signal via T3 and D3. When T2 is off and T3 is on, C9 is charged similarly. Capacitor C10 retains its charge, since D3 prevents it being discharged. Since the two capacitors are in series, the output voltage is twice the input potential.

Owing to the multiple inversions of both signals following the delay networks, it is impossible for T2 and T3 to be switched ON simultaneously. Capacitor C1 buffers the input signal, so that its loading is constant in spite of the varying current drawn by the circuit.

It is essential that D2, D3, T2 and T3 are well cooled. It is best to mount these components on a common heat sink.

The bold lines in the circuit diagram represent heavy-duty wires that should be as short as possible, since they carry a current of 6 A. A carefully constructed converter should give an efficiency of 94% (at 22.2 V and 1.8 A). Input and output voltages for DC to DC converter with a load current of 2 A are:

Wise Tech

Recent Posts

Simple Power Supply Concept Schematic Circuit Diagram

Enhanced Power Supply Alternatives: Simple power supply concept: Common alternatives to a 'quick and dirty' power supply include the three-pin… Read More

Logic Level Tester Schematic Circuit Diagram

Logic Level Display on the Seven-Segment Tester: This tester employs a seven-segment common-cathode display to indicate whether the input is… Read More

Automatic Power-Off Schematic Circuit Diagram

Power-Off Circuit for Load Disconnection: The power-off circuit serves the crucial function of automatically disconnecting any load from a battery.… Read More