High Voltage Circuit DiagramsIndustrial Circuit Diagrams

General transformer PCB

The board may be used in as AVU shown in Fig. 1 or as in Fig. 2 ‘with a transformer rated from 1.5 VA to 12 VA. When used with a very small transformer, it is possible to cut off the part marked K2—K4. Place the terminal strips in the same position along the new edge as they were original.

When non-short-circuit-proof transformers are used, a fuse in the mains entry plug is essential.

General transformer PCB Schematic diagram

General transformer PCB Schematic diagram

Parts list
K1 = two-way terminal block. pitch 7.5 mm

K2, K3, K4 = two-way terminal block, pitch 5 mm

Tr = transformer for PCB mounting PCB Ref. 934004

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
Close
Close
Read previous post:
Single-IC timer

Timer chip 1CM7250 from Maxim enables a very simple timer to be designed. The IC has eight programmable inputs for...

Close