SIMPLE TUBE QUENCHING METHOD SCHEMATIC CIRCUIT DIAGRAM
In fact, it is not a complete method of shocking is not a healthy method 🙂 If the tube can not be recovered by classical shock on television or monitors can be used in a method of how much life if you say that a definitive answer can not be changed according to use is not much. I used this method more on monitors but it should be used as the last solution if it does not get a good result after insertion to save the tube
Turn off the power to the process of disconnecting the electrical connection is usually known as a ring wire with a single core wire cables have plenty of cables 🙂 EHT transformer 1 turn to the core of the transformer tube card to the end of the flame + disconnect the card from the card completely disconnect one end of the wire is separated + to the other part of the chassis to solder this Take the tube as simple as if the result is not good but try to wind 2 laps again:
Our operation is to give more than the normal operating voltage to the filament.
In addition, I want to add a simple handy circuit shock and emission measurement can be done
TUBE SHOCK AND EMISSION MEASURING SCHEMATIC CIRCUIT
t can be used by removing three separate terminals for RGB or using the commander with a single circuit available.
Insert the appropriate socket into the tube to be shocked Set the voltage of the fan to 6 volts.
+1 indicates that the cathodes are in good condition
ensure that the filaments are thoroughly warmed up before starting insertion
To shock the cathode with low emission, press the tank for one second to repeat until the lamp in the shock circuit turns off. press the button to return the voltage to 6 volts and continue the freezing process.
Important Note: Use only 9 volts and 12 volts at very low emissions.
The TV or monitor must be switched off