SLOW START CYCLE FOR INCANDESCENT BULB SCHEMATIC CIRCUIT DIAGRAM
It is a slightly different logic of the circuit, which was shared in the ” Simple 220V Soft Start Circuit ” previously, but it has been seen that the sudden overloading of the problems caused by the sudden overloading of the circuit breaks down when a number of classical incandescent lamps are opened.
The slow start cycle is about 3 seconds past full time, when the power is off, it is zero within 30 seconds, so if you turn on the lamp constantly, there is not a slow start after one time
IMPORTANT: The triac BT136-600E outer shell used in the circuit is connected to the high voltage of the screwdriver zone so that it does not touch any part of the divider touch. The circuit is operating with a high voltage. Be careful with the capacitor connections. + – If you reverse polarity, there may be large explosions at high voltage. Before operating the circuit,